Welcome on the Euronorm product configurator
Menu

Planetary Gearbox

Introduction: The planetary gearbox units are modular and consists of different types of end stages, gear ratio’s and various input flanges and shafts. The input side of the planetary gearbox units are suitable for IEC motors, couplings and hydraulic motors…

The output side also has several options: hollow shafts with shrink disc mounting, cylindrical shafts with keyway or spline. Optionally spline welded bushings or flanges are also possible.It is possible to make many different combinations, because of the modular construction of the planetary stages. This allows it to almost always create the desired transmission.

Product description JRP

JRP Series Planetary Gear Units are reliable drive components tor the use in different industrial sectors. The products have proved themselves under different operating conditions. The JRP9-36 size series covers a nominal torque range between 22,000 and 2,600,000Nm.

The modular design permits standardization of many basic components, including planetary gear stages and housing parts as well as input side and output side components. Manufacturing with short lead time is possible as well as local assembly from stock parts. the heavy loaded housing parts are made of ductile cast iron, the sun and plane gears are hardened and ground, solar gears are extra hardened and ground.

Depending on the application and mounting possibilities, there are many input and output shaft types to choose from

General Information

Illustrations are examples only and not strictly binding. Dimensions are subject to change. The weights are mean values and not strictly binding. To prevent accidents, all rotating parts should be guarded according to local and national safety regulations.

Prior to commissioning, the operating instructions must be observed. The gear units are delivered ready for operation but without oil filling. Oil quantities given are guide values only. The exact
quantity of oil depends on the marks on the oil dipstick. The oil viscosity has to correspond to the data given on the name plate.

The gear units are supplied with radial shaft seals. Other sealing variants on request. Directions of rotation referring to output shaft d2.

Configure your product
Configure your product